Graco Therm-O-Flow Plus, Instructions Manual

Page: 40 / 82

40 309085
Advanced Pendant Control
Manual Send SV Temperatures
The pendant can be used to quickly change the SV of
any zone on the Therm-O-Flow Plus system. It can
also be used to place any zone in RUN or STOP mode
with a push of the R key (RUN) or the S key (ST OP).
The MAN (manual) function of the pendant can be
useful for troubleshooting zones or sending SV tem-
peratures to zones that may not have been preset
within recipes.
To access the MAN (manual) screen, from the MAIN
screen, press F3 (MAN).
G R A C O T O F + P E N D A N T
T h u r R e v 1 . 2 1 X \
0 8 / 1 5 / 2 0 0 0 1 7 : 3 5 : 2 3
V I E W T R M A N X O S E T U P
F1 F2 F3 F4 F5
M A N U A L S V – S E N D / < R / S
Z O N E # 0 1
S V : 2 5 0 F Z O N E ^ ^
Z N – S N D E X I T C H G Z N +
F1 F2 F3 F4 F5
Here, the zones can be incremented up and down
using the F1 (ZN–) and the F5(ZN+) keys. Pressing
the F2 (SND) key will send the SV shown on the
display to the zone shown. Note that incrementing
through the zones will keep the same SV temperature
setting. This makes it easy to set all zones to 250
F,
for example. Press F1(SND), increment to the next
zone by pressing F5 (ZN+), and press F2 (SND) again
until all zones are set to 250
F.
The <R/S at the top of the screen represents the same
operation the <R/S key of the Syscon RKC CB–100
temperature control on the control box door. Pressing
R on the pendant keypad will RUN the displayed zone,
while S on the keypad will STOP the zone.
To change the SV temperature setting, press F4
(CHG). The following screen will be shown.
M A N U A L S V – S E N D / < R / S
Z O N E # 0 1
S V : _ Z O N E ^ ^
E N T E R w h e n d o n e
F1 F2 F3 F4 F5
Use the numeric keys to enter the desired tempera-
ture. Press the ENTER key when done. The new SV
temperature will be displayed. The screen will return
to the previous screen where you may increment the
zones and send the new SV just entered. Pressing F3
(EXIT) will return to the MAIN screen.