![background image](http://html.mh-extra.com/html/graco/roadlazer-roadpak-16n437/roadlazer-roadpak-16n437_operation-manual_2250957013.webp)
Setup
3A2091B
13
Setup
Charge Battery
If the battery is newly purchased or has not been used
for a long time, charge it before you use it.
Grounding Instructions
1.
Attach Tow-Behind System ground clamp to earth
ground.
Level Draw Bar with Tow-Behind
System
Use the following procedure to ensure level operation of
the Tow-Behind System.
1.
Empty tow vehicle of any payload.
2.
Install draw bar to measure approximately 22 in. (56
cm) from top of ball mount to ground.
NOTE:
For initial setup, leave trailer on supplied pallet
until final step of
Connect Tow-Behind System to
Vehicle
procedure.
Connect Tow-Behind to Vehicle
1.
Install two ball mounts in hitch receivers:
a.
Slide ball mount into hitch receiver.
b.
Insert pin.
c.
Insert clip.
TI
3
05
8
A
6244a
22 in.
(56 cm)
If the wheels are not rotated to the rear of the trailer, it
can become unstable and tip over if the tow vehicle is
removed, causing serious injury.
Only remove the Tow-Behind system from its tow
vehicle when the wheels are facing the rear of the
trailer and are blocked on both sides.
ti18281a
ti18279a
ti18138a