Setup
16
3A2091B
Installing RoadLazer onto Trailer
NOTE:
Only install RoadLazer onto trailer if trailer is
properly attached to tow vehicle.
NOTE:
Remove rear jack from trailer before mounting
RoadPak.
NOTE:
If tow vehicle is a pick-up, remove tailgate before
installation.
Load RoadPak onto trailer using a forklift or a hoist that
is rated for the weight of the RoadPak. For RoadPak
weight information see
Technical Data
, page 37.
After loading the RoadPak on the trailer, secure the
RoadPak to the trailer using the supplied bolts, nuts, and
washers. Torque bolts to 28 ft-lb (38 N•m). Replace rear
jack.
Adjustable Gun Arm Beam
Installation (24G630)
The gun arm beam is shipped at 87.75 in. (2.2 m) long
to accommodate wider vehicles. The beam can be cut
down to 75.75 in. (1.9 m) long or 60 in. (1.5 m) long to
accommodate different vehicle sizes.
1.
To shorten the beam to 75.75 in. (2.2 m), cut 12 in.
(30 cm) from the end of the beam towards the next
hole on the beam. To shorten the beam to 60 in. (1.5
m), cut 27.75 in. (70 cm) from the end of the beam
towards the third hole as shown below.
2.
After shortening to the desired length, slide the
beam into the channel in the gun arm beam bracket.
If RoadPak is not properly secured to trailer, it can fall
off of trailer and cause serious injury.
Use only Graco supplied fasteners and tighten them to
the required torque. Use all of the fasteners provided.
ti18377a
ti16665a
ti18137a
ti16600a
12 in.
27.75 in.
ti18144a
