9
308611
Pre-Setup Requirements
Hitch
Have a DRAW-TITE Class IV Ultra Frame receiver
installed on your vehicle (DRAW-TITE Series
419XXX). See manual 308670 for additional
instructions.
Choose a ball mount that allows the RoadLazer to
travel level to the ground with an average payload.
A recommended option is two DRAW-TITE adjustable
2-in. ball mounts. See Fig. 5. The ball mount must
have a 2-in. by 2-in. insert with at least a 1-in. diameter
ball mount hole. The ball mount hole and shank
diameter must match. the ball mount must have a
rating of at least 5000 lb (227 kg) GTW, 500 lb
(227 kg) TW.
Receivers
Two Graco clamp-on receivers must be mounted 32 in.
(81 cm) on center on the installed DRAW-TITE Class
IV Ultra Frame Hitch. See manual 308670 for
mounting instructions. See Fig. 2.
Fig. 2
32 in.
(81 cm)
06196B
Paint Drum Bracket
WARNING
Paint drums are heavy and could shift from side to
side when the tow vehicle is cornering. The paint
drums could fall from the vehicle and cause injury
or death. Secure the drums when the vehicle is in
transport or spraying.
It is recommended that the paint drums be secured
with a paint drum bracket. Graco does not provide the
paint drum bracket with the RoadLazer.
Front Mechanical Guidance System
The Front Mechanical Guidance System (see manual
309008) is mounted on a trailer hitch installed on the
front of the tow vehicle. The receiver is a single 2-in. x
2-in. as shown in Fig. 3. Graco does not provide the
receiver.
Hitch receiver
Fig. 3
06243B
Programmable Skipline Controller
The Programmable Skipline Controller is installed in
the cab of the tow vehicle. Select a position for ease of
operation. This control system connects to the
RoadLazer with an I/O cable, so there must be a cable
access from the tow vehicle cab to the RoadLazer.
See manual 308616.
