13
308611
Operation
Prepare System to Paint (Cont.)
Start Engine
1. Set POWER ON/OFF on Programmable Skipline
Controller to ON.
2. Set hydraulic bypass valve to BYPASS position.
Fig. 6.
WARNING
FIRE AND EXPLOSION HAZARD
Gasoline is extremely flammable and
explosive under certain conditions. Fuel
could spray from the fuel line connector
when it is disconnected from engine.
Fuel could come in contact with the hot
muffler and cause fire or explosion. To reduce the
risk of fire or explosion, always vent the fuel tank
and allow engine muffler to cool before you discon-
nect the fuel line.
3. Carefully connect RoadLazer fuel tank (AB on
page 6) fuel line to engine (U on page 6).
4. Open fuel tank vent.
5. Prime fuel line.
6. Pull choke out.
7. Set throttle.
8. Turn key. Fig. 7.
Fig. 7
06248
9. After engine starts, push choke in.
10. Set throttle to lowest setting.
Select/Prime Pumps
1. Turn pump lever(s) (A) to select desired paint
pump(s).
2. Set throttle to half speed.
3. Open all drain valves.
4. Place paint suction hoses in drums of
solvent/water.
5. Close hydraulic bypass valve to activate pumps.
6. When water or solvent comes out of drain valves,
set hydraulic bypass valve to BYPASS position
7. Place suction hoses in paint drums.
8. Close hydraulic bypass valve to activate pumps.
9. When paint comes out of drain valves, set
hydraulic bypass valve to BYPASS position
10. Close all drain valves
Prime Guns
1. Open only spray gun ball valves corresponding to
paint pumps or color used.
NOTE:
Never open
both ball valves on the two-color gun at the same
time. Paint color contamination could result.
2. Turn guns on with Programmable Skipline
Controller.
3. Place an empty pail under spray guns to catch
drainage from spay guns.
4. Close hydraulic bypass valve to activate pumps.
5. When paint comes out of spray gun, set hydraulic
bypass valve to BYPASS position.
6. Turn off guns with Programmable Skipline
Controller.
7. Set hydraulic pressure control knob to maximum or
slightly lower.
8. Select air pressure on pressure tank regulator.
Turn on Bead System
1. Turn bead system valve to ON position. Set
desired bead tank pressure.
2. Remove and secure ground strap from earth
ground.
3. System is now ready for painting. Select guns 1 or
2 with the Programmable Skipline Controller.
Begin to Spray
Select appropriate procedure from menu on
RoadLazer control system. See manual 308616.
