5
308611
Introduction and General Information
INTRODUCTION
This manual and those listed below provide pre-setup
requirements, parts lists, setup, operation, and
maintenance instructions for the RoadLazer system.
This manual includes parts lists and instructions for a
3-pump system. For 1- and 2-pump systems, all parts
remain the same with the exception of plugged parts
for missing pumps.
D
308612: Bead Spray Gun
D
308613: Paint Spray Gun
D
3A1215: Programmable Skipline Controller
D
309008: RoadLazer Guidance System
D
312484: Viscount I Hydraulic Motor
D
308650: Displacement Pump
D
308674: Viscount I Hydraulic Motor
and Displacement Pump
D
308670: Hitch Receiver Kit
D
308671: Unpacking Instructions
GENERAL INFORMATION
The RoadLazer is attached to a tow vehicle and is
used to stripe up to two stripes in one or two colors
with glass beading.
The RoadLazer consists of a Programmable Skipline
Controller, a Front Mechanical Guidance System, three
Viscount I Hydraulic Motors, three Displacement
Pumps, two Paint Spray Guns, and two Bead Spray
Guns.
Programmable Skipline Controller
The Programmable Skipline Controller consists of the
control box and a 30 ft cable. It is the main control for
the RoadLazer system and turns the spray guns and
accessories on and off.
Front Mechanical Guidance System
The Front Mechanical Guidance System provides the
operator with a bore sight view for alignment on either
the left or right side of the tow vehicle. See manual
309008.
Video Guidance System
t
(optional)
The Video Guidance System provides the operator
with video of a bore sight view for alignment on either
the left or right side of the tow vehicle. The system
consists of a 6 in. x 5.5 in. monitor, interfacing cables,
video camera and mounting bracket.
Viscount I Hydraulic Motors
The Viscount I Hydraulic Motors power the
displacement pumps to supply paint to the spray guns.
There are three hydraulic motors. Two hydraulic
motors power the yellow-paint displacement pumps,
and one powers the white-paint displacement.
Displacement Pumps
The Displacement Pumps supply paint to the spray
guns. There are three displacement pumps. Two
displacement pumps provide paint to the two
yellow-paint spray guns, and one provides paint to the
white-paint spray gun.
Paint Spray Guns
The Paint Spray Guns are pneumatically triggered to
spray paint stripes when commanded by the
Programmable Skipline Controller.
Bead Spray Guns
The Bead Spray Guns are pneumatically triggered to
spray glass beads when commanded by the
Programmable Skipline Controller.
Receivers
The two clamp-on receivers are mounted on the
installed trailer hitch to provide receptacles for 2 in. ball
mounts. See manual 308670 for receiver mounting
instructions.
