Device Description HG G-98780-A | English, Revision 16 | Date: 15.07.2021
29
Software – Chapter 6
In order to start the monitor mode, first of all you have to switch the antenna off and
on again. After 10 s (resp. 26 s) you can transfer the appropriate *.txt file from the
disk with your terminal program. The following four files are on the disk:
1.
Mon3964r.txt
Transfer if the system is preset to procedure
3964R
with „
HighByte first
“. The
file contains in hexadecimal notation the following characters:
0x02 0x4D 0x4F 0x4E 0x49 0x10 0x03 0x16
2.
Mon6439r.txt
Transfer if the system is preset to procedure
3964R
with „
LowByte first
“. The
file contains in hexadecimal notation the following characters:
0x02 0x4F 0x4D 0x49 0x4E 0x10 0x03 0x16
3.
Montrans.txt
Transfer if the system is preset to procedure
Transparent
with „
HighByte
first
“. The file contains in hexadecimal notation the following characters:
0x3D 0x4D 0x4F 0x4E 0x49 0x38
4.
Transmon.txt
Transfer if the system is preset to procedure
Transparent
with „
LowByte
first
“. The file contains in hexadecimal notation the following characters:
0x3D 0x4F 0x4D 0x49 0x4E 0x38
Transferring a file with HyperTerminal is done as follows:
1.
Choose
Send Text File
from the menu
Transfer
. The following window
will opened up (partly German version):
Figure 13
Transferring a file with the terminal program
2.
Switch to disk drive (in our example, the files are located on the hard disk) and
select the respective *.txt file.
3.
Click ’open’. The file will be transferred and (if the correct file has been selected)
the monitor program will be started. The menus will then appear directly within
the HyperTerminal Window. First, the main menu is displayed (Figure 14).
6.2.2 Operating the monitor program
Any change to the interface parameters will be activated after a system reset (switch
the antenna off and on again). Afterwards it may be necessary to use a different file
from the four given *.txt documents for the monitor call!
Once the transfer of the *.txt file (refer to section 6.2.1) has been completed, the
monitor program will start with the main menu. If this is not the case, you have either
based your settings on a wrong system configuration, or you are using a different
terminal emulation, or you did not adjust the character delay to 1 ms, or you did not
wait at least 10 s after activating the antenna.
