Device Description HG G-98780-A | English, Revision 16 | Date: 15.07.2021
38
Chapter 6 – Software
Figure 20
Update program: Operating Elements
Start the programming process by switching on the antenna and then click
Pro
-
gram
within a period of 10 seconds afterwards. A device reset follows and after a
short period of time, the file is being transmitted.
Figure 21
Update program: programing procedure
Once the programing process is completed, the program can be closed (
close
).
From now on, the interpreter uses the new program.
2 Selection of the serial interface
1 Selection of the Hex file to be
5 Status messages
4 Start the programming
6 Exit the program
transmitted
3 This option must always be
activated
and baud rate
procedure
Should an error occur during the
transmission, red coloured status
messages are output. As long as
green coloured messages are out
-
put, the software update is correct.
The last 2 messages of a normal
update procedure are:
Program
-
Flash: Ok
and
CloseCom: Ok
