76343/4/5 | English, Revision 05 | Date: 23.02.2022
45
Parameter Setting via the Web Interface – Chapter 5
Configuration tool accessibility
: With this setting the access for the MC-Config tool
can be restricted:
WLAN+LAN
LAN
none
Other options
: Here you can define how many serial ports are to be used. The num
-
ber of serial ports can be extended by connecting suitable adapters to the USB port.
Power Save
: With this option it is possible to set the radio modem to a power-saving
mode for a certain time. During this time, the module consumes only about 1/3 of
the typical power. In this state, however, the module cannot communicate. After the
specified time has elapsed, the module reports back with a status datagram. For
how to use the power save function please contact the service.
Webserver certificate
: With this function it is possible to upload a certificate for the
web server of the radio modem. This certificate replaces the device-internal self-
generated certificate that generates an waring message when the web page is
called via https.
5.3.2 Network Menu
Allows to change the network settings of the device‘s LAN port.
5.3.2.1 IP Address
Figure 36
Web interface: Network > IP
settings
Enable DHCP Client
: By activat
-
ing this option, the radio mo
-
dem obtains the network set
-
tings via DHCP. Usually this will
be done over an existing WLAN
connection. If this parameter is
empty, the
Device Name
from
the Admin page is used.
Enable Fallback to Static IP
: In
case no DHCP server can be
reached the radio modem uses
the static settings.
IPv4, Subnetmask, Gateway,
DNS
: Without DHCP, the net
-
work parameters that the radio
modem uses via
WLAN
are set
here. Only in
Pseudo Level 2
Bridge Mode
is this IP address
also active via LAN.
