Gorilla Playsets 1500KWR, Manual

Page: 128 / 188

22 12 "
2 12 "
UNFINISHED END
1-1/4" WOOD SCREW
ROOF BATTEN
ROOF FINISHER FLUSH
(TOP SECTION)
CUT THIS SIDE
1 X 2 X 32" ROOF BATTEN
" 2 12
32"
STEP 68: ROOF BATTEN
ROOF FINISHER. INSERT 1-1/4" WOOD SCREWS THROUGH THE PRE-DRILLED HOLES
ALONG THE BATTEN.
ALONG THE BATTEN.
2: THE REMAINING 1 X 2 X 32" ROOF BATTEN WILL BE CUT TO FIT THE REAR ROOF PANEL SECTION. MEASURE FROM
THE BOTTOM END 22-1/2" TO THE TOP, MAKE A MARK WITH A PENCIL. USING A HAND SAW OR AN ELECTRIC SAW,
CUT THE TOP SECTION OF THE ROOF BATTEN. FOLLOW THE DIRECTIONS IN THE DIAGRAM BELOW FOR PROPER
MEASURING.
SHORTENED ROOF BATTEN
BOTTOM
END
1: PLACE THE 1 X 2 X 32" ROOF BATTEN UP AGAINST THE FRONT ROOF PANEL, CENTERED BETWEEN THE ROOF
SUPPORTS, FLUSH THE BOTTOM EDGE OF THE ROOF BATTEN TO THE BOTTOM EDGE OF THE SEVENTH ROOF BOARD,
MAKE SURE IS PARALLEL TO THE ROOF SUPPORTS. INSERT 1-1/4" WOOD SCREWS THROUGH THE PRE-DRILLED HOLES
3: ONCE THE ROOF BATTEN HAS BEEN CUT TO 22-1/2", PLACE IT AGAINST THE REAR
ROOF PANEL. THE UNFINISHED END (TOP END) MUST BE POINTING TOWARDS THE
ROOF PEAK, AND THE BOTTOM END MUST BE FLUSH TO THE BOTTOM EDGE OF THE
120