Gorilla Playsets 1500KWR, Manual

Page: 125 / 188

PULL TOWARDS
YOU
WOOD SCREW
1-1/2"
NOTE:
CORNER POST
REMOVED FOR
CLARITY.
33-7/8"
" 6 78
33-7/8"
DISTANCE (DO NOT FASTEN). IF NECESSARY SLIDE THE GABLE ASSEMBLY LEFT OR RIGHT UNTIL FINAL POSITION IS
IT IS RECOMMENDED TO TEST FIT THE 1 X 4 X 29.29" ROOF FINISHERS FRONT LEFT AND RIGHT TO ASSURE THIS EQUAL
FRONT SECTION.
TIP: MAKE SURE THE DISTANCE BETWEEN THE GABLE ASSEMBLY AND THE ROOF OVERHANG IS EQUAL ON BOTH SIDES.
2: THE GABLE ASSEMBLY BOTTOM COUNTERSUNK HOLES WILL REMAIN EMPTY FOR NOW.
ACCOMPLISHED.
1: MOUNT THE GABLE ASSEMBLY RESTING ABOVE THE TOP PANEL BOARD, MAKE SURE THE GABLE ASSEMBLY IS
FLUSH AGAINST THE FRONT CORNER POSTS. THE GABLE ROOF PEAK SHOULD BE RESTING ON TOP OF THE ROOF
3: AFTER THE GABLE ASSEMBLY IS IN ITS FINAL
POSITION. GO INSIDE ON TOP OF THE DECK AND
PULL THE GABLE ASSEMBLY TOWARDS YOU
MAKING SURE IT IS FLUSH TO THE OUTSIDE OF THE
ROOF AND INSERT TWO 1-1/2" WOOD SCREW
FROM UNDERNEATH THE ROOF INTO THE
GABLE ASSEMBLY ROOF PEAK. USE THE
DIMENSIONS SHOWN IN THE DIAGRAM TO THE
LEFT TO INSERT THE WOOD SCREWS IN THE
CORRECT LOCATION.
REMOVE THE ROOF
FINISHERS, THESE WILL BE USED IN A LATER STEP.
STEP 65: ATTACHING THE FRONT GABLE
TOP PANEL
1 X 4 X 29.29" ROOF
FINISHER LEFT
SLIDE LEFT
OR RIGH
T
GABLE ASSEMBLY
ROOF OVERHANG
(TEST FIT ONLY)
ROOF OVERHANG
EMPTY
(TEST FIT ONLY)
1 X 4 X 29.29" ROOF
FINISHER RIGHT
EMPTY
EQUAL
EQUAL
117