Normal Pattern Sewing Computerized Control System for Square Buttonhole Machine
38
No. Item
Range
Unit
Remarks
S22
1
st
Clearance
This item sets the clearance between 1st bar-tacking and knife
groove. This item is applied to all shapes
0.0~4.0 0.1mm
S23
2
nd
Clearance
This item sets the clearance between 2nd bar-tacking and knife
groove. This item is applied to all shapes
0.0~4.0 0.1mm
S31
Single/ Double Sewing
：
Single Sewing
：
Double Sewing
S32
Select Cross at Double Sewing
At setting the double sewing, user can select parallel sewing
and crossing sewing
：
Parallel Sewing
：
Cross Sewing
Remark
3
S33
Compensation of Double Sewing Width
This item sets amount to narrow over-edging width of 1st
cycle at double stitching.
0.0~2.0 0.1mm
Remark
3
S34
Number of Basting Times
This item sets number of basting times.
：
Without basting
：
1~9
0~9 1
Time
S35
Basting Pitch
This item sets pitch at performing the basting.
1.0~5.0 0.1mm
Remark
3
S36
Rolling Length of Basting
This item sets rolling length of needle thread at performing
basting.
2.0~20.0 0.1mm Remark
3
S37
Rolling Pitch of Basting
This item sets rolling pitch of needle thread at performing
basting.
0.2~5.0 0.1mm
Remark
3
S38
Rolling Width of Basting
This item sets rolling width of needle thread at performing
basting.
0.0~4.0 0.1mm
Remark
3
S39
Lengthwise Compensation of Needle Entry at Basting
This item sets the amount to move needle entry position back
and forth at performing basting more than two cycles
0.0~2.5 0.1mm
Remark 2
Remark 3
S40
Horizontal Compensation of Needle Entry at Basting
This item sets the amount to move needle entry position left
and right at performing basting more than two cycles.
0.0~1.0 0.1mm
Remark
3
