Mode Setting Computerized Control System for Square Buttonhole Machine
90
（5）
Correction of Touching Panel
A
、
In the interface of Mode Inspection, Press
(I05
Correction of Touch Panel). Then system will hint user
【
Enter
Touching Panel Correction Mode?
】
. Press
to enter the
interface for Touch Panel Correction (as shown in right figure).
Press
to quit the correction status.
B
、
Because the corrections for five spots are needed, the user
had better click the cross icon on the screen with tools like
touching pen. After the correction, the system will tell user that
this operation is successful or not.
※
During the correction, please do perform the operation
according to the positions of crosses. Otherwise, the touching
panel will be unable to work normally after the correction.
（6）
Output Inspection
In the interface of Mode Inspection, Press
(I06 Output
Inspection) to enter the interface of Output Inspection (as shown
in the right figure). The following output status of the solenoid
can be checked under that interface.
：
A
：
Needle-rocking Motor Test
B
：
Presser Motor Test
C
：
Bobbin Thread-trimming Motor Test
D
：
Cloth-feeding Motor Test
E
：
Needle Thread Motor Test
F
：
Tension Solenoid
G
：
Knife Solenoid
When user presses A~E, the system will
display
. Press
【
+
】
and
【
-
】
to display
the motor origin test status.
At user pressing F~G, the corresponding solenoid will
move
Press
to quit output inspection interface
※
Attention: Sewing machine will perform relating actions.
