Normal Pattern Sewing Computerized Control System for Square Buttonhole Machine
36
No. Item
Range
Unit
Remarks
S02
Length of cloth cutting
This item sets the length of cloth that is cut by knife. However,
in case of the shapes of No. 27, 28, 29 and 30, sewing length
will be set. When activating U19 parameter (knife action
number), the machine will cut the fabric according to the value
in U18 (knife size).
3.0~120.0 0.1mm
S03
Knife groove width, right
This item sets the clearance between knife and right parallel
section.
-2.00~2.00 0.05mm
S04
Knife groove width, left
This item sets the clearance between knife and left parallel
section.
-2.00~2.00 0.05mm
S05
Over-edging width, left
This item sets the over-edging width of left parallel section.
0.10~5.00 0.05mm
S06
Ratio of right and left shapes
This item sets scale ratio of right side shape with the knife
position as the center
50~150 1%
S07
Pitch at parallel section
This item sets sewing pitch between left and right parallel
sections.
0.200~2.500 0.025mm
S08
2nd bar-tacking length
This item sets length of bar-tacking on the front side
Square Down
Bar-tacking Down
Taper Down
0.2~5.0 0.1mm
S09
1st bar-tacking length
This item sets length of bar-tacking on the rear side
Square Up
0.2~5.0 0.1mm
S10
Compensation of bar-tacking width, right
This item adjusts right over-edging section. of bar-tacking part
Both 1st and 2nd bar-tacking can be adjusted
Square Up
Square Down
Bar-tacking Down
-1.00~1.00 0.05mm
S11
Compensation of bar-tacking width, left
This item adjusts left over-edging section of bar-tacking part
-1.00~1.00 0.05mm
