23
5.
TYPE
: patient type, Adult or Neonate options
6.
STORE INTERVAL
: adjustable at 12 seconds
7.
SAVE
: to store the changed data (this needs to be confirmed by the new
menu due to possibly substitution to the original data of the same ID
of patient)
8.
EXIT
: to quit the current menu but not to store the changed setup
Chapter VI
Charging, Maintenance, Cleaning
I. Charge
Connect the AC/DC power adapter via the Mini USB port turn on the unit.
The unit will charge the battery with power at the same time as operating.
The battery charge will end after battery is full.
The battery of this unit is a long life rechargeable lithium battery. When the
unit is operated on battery only the battery indicator shows the battery’s
charge level on the screen. When the battery charge level is low, the indicator
will flash red , and the external 5VDC power must be connected as soon
as possible.
After DC power is connected, the monitor will recharge the battery, and will
stop charging after the battery has fully recharged. Operation time for a
fully charged unit is > 10 Hours. Charge time is approx. 4 Hours.
Battery replacement method:
Note that the operation must be done with the DC Charger disconnected
ensuring that the operator’s safety is not compromised.
Press down and slide off to remove the battery cover, then carefully
disconnect and remove the battery. Reverse this procedure to replace
the new battery and re-fit the battery cover.
NOTE
: Any battery that is removed and no longer required must be properly
disposed of by following national and local regulations.
II. Maintenance
If the monitor appears abnormal (e.g. software system is halted), then to
reboot the device hold the Power ON/OFF button down for 5 seconds.
OCCLUSION: If the Display shows ‘occlusion', check if the filter/water
trap and/or sampling line tubing or connectors are blocked.
Replace as necessary and clear the occlusion or switch OFF to prevent
damage to the sampling pump.