GILES GBF-35, Operation & Service Manual

Page: 50 / 104

1. Ensure that the HEAT switch ① is in the [OFF] position.
2. Place the POWER switch ② in the [ON] position.
The green POWER light ③ will illuminate, the controller
powers up and then sounds an alarm. The message
“ POWER FAILURE [PRESS START TO PREHEAT]” is shown
on the upper display screen ④ This is normal ... to
safeguard against fryer from beginning to heat while
unattended, such as after power interruptions. Press the
[START] key ⑤ to silence the alarm and place fryer into
PREHEAT mode. The upper display screen shows the cook
settings last used. The controller HEAT indicator adjacent
to the lower display screen turns ON , but until the control panel HEAT switch ① is placed in
the [HEAT] position, heating elements will NOT be energized .
DO NOT place HEAT switch in the [HEAT] position until fry vat has been filled with
cooking oil (or water).
3. See Section 4.02, Cooking Procedures .
44
Fryer Operation
GBF − 35 / GBF − 50 Fryers
4.01.9 PASSWORD Protection
4.01.10 Power Up Procedure
1
4
5
4.01.8 User Settings − continued
2 3
NAME DESCRIPTION RANGE DEFAULT
LANGUAGE Sets the controller language
English ­ Spanish ­
French
English
COOK ON MENU
SELECT
*
If set [ON] , selecting a MENU # to cook will automatically begin
the timer cycle. Reduces the number of keystrokes needed to
start a cook cycle.
ON ­ OFF OFF
[0] KEY EXTRA TIME
If [ON] , operator can add extra time to cook cycle (after or
during the cycle) by pressing [0] + the number of minutes to
add.
ON ­ OFF OFF
* Setting is available ONLY on dual ‐ timer controllers.
It is possible to add PASSWORD protection for certain controller settings. This feature is a FACTORY SETTING that is
typically DISABLED . If PASSCODE ENABLE is set to [ON] , you are prompted to enter a password before performing
many controller operations.
If you desire to have password protection enabled, or have questions concerning this feature, call
Giles Technical
Services at 800.554.4537 to request the passcode and instructions as to how to enable the feature.