GILES GBF-35, Operation & Service Manual

Page: 13 / 104

GBF − 35 / GBF − 50 Fryers
Installation
7
2.04 Electrical Specifications (per fryer unit)
Voltage
Phase Hz Watts
Amps Circuit Breaker Required
208
1 60 10,000 50 60
3 60 10,000 28 35
3 60 18,000 51 60
240
1 60 10,000 43 50
3 60 10,000 24 30
3 60 18,000 44 50
380 ­ 415 3 50 15,000 ­ 18,600 26 ­ 28 35
2.05 Electrical Connections
1. As needed, install appropriate circuit breaker(s) in main electrical panel. See Section 2.04.1 .
2. Optional: Giles recommends that a service disconnect switch be installed between the main panel and the
appliance, such that all power may be easily removed from the unit when necessary.
3. See Section 2.05.1 . Route 1 ­ 1/4” flexible conduit from panel (or disconnect switch) to the appliance and attach
it to the rear of the service entrance box located on the front cabinet brace with appropriate fittings. Allow
enough conduit length so that appliance may be easily moved for cleaning and servicing.
4. See Figure 2.05.1 . Open cabinet door and remove service box cover .
5. Connect ground wire between the copper ground lug and a proper earth ground.
6. Pull appropriately sized wires from the panel (or disconnect switch) through to the service entrance box.
7. See Figure 2.05.1 . Connect power supply wires to the distribution block located inside the service box and
reinstall cover.
8. On multiple unit systems, each unit in the battery requires a separate power supply to be connected as
described above.
NOTE:
All electrical installation labor & material (breakers, conduit, wire, etc.) expenses shall be the sole responsiblity
of the customer. Electrical installation must be performed by a licensed electrician, or qualified service
technician, and comply with all local building codes.
Giles shall not be held responsible for code compliance with regard to installation and use of this appliance.