GILES GBF-2-GVH Series, Operation & Service Manual, Page: 50 / 140

38
GBF-2-GVH Ventless Fryer Pre-Operation Tests
Before cooking product with the appliance, a Boil-Out procedure must be performed to remove dirt and debris that may
have accumulated in the fry vats during shipment, and to completely remove any remaining manufacturing residue or
oils. Follow instructions in Section 6.01, Boil Out Procedure . After performing this procedure, proceed to Section 4.06
below.
38
The following test is to confirm that the Filter Pump is operating correctly (not running in reverse).
1. Set-up as described in Section 4.01 except
leave Fryer Power Switches ① in the [ON]
position and Hood running. Confirm [HEAT]
Switches are [OFF] .
2. Open right-hand Cabinet Door. If not
previously done, disconnect and remove the
Filter Pan from the Unit.
3. Firmly press the palm of the hand over the
Filter Pan Quick-Disconnect ① opening.
4. While covering the fitting with hand, place the Pump Switch ② in the [PUMP]
position. Pump should run ... if suction is felt on your hand, it is operating
properly. Return switch to [OFF] ... ONLY allow pump to run long enough to
check for suction. Proceed to Section 4.05 .
If results are as described above, proceed to Section 4.05 ...
if not, refer to Section 7.01, Troubleshooting Procedures .
4.04 Filter Pump Test
1
Right-hand Panel
2
4.05 Boil-Out Procedure