GF CNC 4.0 400, Instruction Manual

Page: 64 / 200

9 Machine Set-up Operating instructions CNC 4.0 400/500/630
58
Use the touch keyboard for data input, then confirm it by pressing the
Enter button. To move to next field push ‘down’ button. To get back to
traceability data input page press button ◄.
Traceability data must be read by means of the smartphone (WeldinAir
app - see chapter 10.5), then the traceability code (according to
standard ISO 12176-3) is displayed at top of the page and the included
dimensions (single-double diameter, SDR) are shown as well.
Push
►
button to get the traceability data input for pipe/fitting at right
side, then repeat the procedure for barcode scanning.
Push again
►
button to proceed with fusion preparation (chapter 8.2)
It is possible to switch from left to right pipe/fitting by pushing the ◄ ►
buttons to check traceability information: be careful that, if you push ◄
button from left pipe page, the complete traceability data will be reset
If read barcode doesn’t comply with standard ISO 12176-3 or it is not
clearly readable (e.g. too much reflection of printed surface, dirt) the
following error message appears:
Attention
Attention