GF CNC 4.0 400, Instruction Manual

Page: 44 / 200

8 WELDING Operating instructions CNC 4.0 400/500/630
38
If REPEAT BEAD mode is selected (see chapter 9.5.1) and the same
parameters (standard, diameter, SDR) are used for the next consecutive
welds (see chapter 8.3.7), the system will consider the same time t1
manually confirmed in the first weld and automatically release the
pressure after the countdown: therefore the button will not be
displayed anymore and the message “Repeat Bead” appears.
The message “Repeat Bead” will be also displayed in the Selected
Parameters summary (see chapter 8.1.4).
If NBN T 42-010 standard is selected (see chapter 8.4.3) the system skips
the Bead Build-Up phase and directly goes to the next phase.
To stop the process immediately push the button . After this action
the CLAMP PIPES & ALIGNMENT page will appear to enable to move the
carriage! The message “welding interrupted!” will be also displayed
.
Attention
Attention
Attention