GF CNC 4.0 400, Instruction Manual

Page: 38 / 200

8 WELDING Operating instructions CNC 4.0 400/500/630
32
If the pipe ends are properly faced, confirm by pushing the button OK
and the display moves automatically to the next page.
To repeat the planing procedure get back by pushing the button ◄.
If the planing is stopped before the message “Minimum step achieved”
appears, the display moves a step back to re-start the procedure.
To stop the process immediately push the button . After this action
the CLAMP PIPES & ALIGNMENT page will appear to enable to move the
carriage!
In case of risk to injure the operator or to damage the machine push the button
.
When planing is completed, extract the planer and remove shavings
from the welding area and also in the pipe, for example with a brush. If
you have touched the pipe ends, the fusion surfaces must be cleaned
with lint-free paper and cleaner like trichlorethylene or pure industrial
alcohol (such as "Tangit KS").
After cleaning, never touch the fusion surfaces again!
Be careful not to exceed the duration of the planing process more than
15 minutes! Prolonged use can lead to overheating of the pump motor! In
this case, the pump and plane motor stop and the symbol below appears
on the screen.
Attention
Warning
Advice
Advice