GEZE UFO-NT F, Wiring Diargam

Page: 74 / 80

UFO-NT
74
Service menu
DPS Parameter Setting values Explanation
12 Stop 12 kOhm NO For the connection of a stop push button with 12 kOhm termi-
nating resistor
13 Reset switch NO For restarting the drive. Function as reset.
14 Double push button NO Open 1× press = 1 leaf open
Open 2× press = 2 leaf open
15 Stop NO NO For connection of a stop push button
16 Stop NC NC
19 Closed position SF closed position contact for the passive leaf for 2-leaf door with
manual passive leaf (door closer):
20 Stop 20 kOhm NO For the connection of a stop push button with 20 kOhm termi-
nating resistor
21 WC control Connection of the internal button
for the WC function.
22 Fire alarm If active, the door opening torque function with fire alarm
torque is set for the duration.
23 1-leaf opening In 2-leaf systems, when the signal is active on the active leaf only
1 leaf is opened.
a1
Configurable
output 1
00 Not used
a2
Configurable
output 2
01 Gong If KA is triggered
02 Fault NO contact The function is used for fault messages, e.g. to a customer build-
ing control centre. The contact closes or opens respectively if
the control determines a fault.
03 Fault NC
04 Fault MPS The function is used to switch the fault LED at the MPS. The con-
tact closes if the control determines a fault. When maintenance
is due, the output is connected cyclically, and the fault LED on
the MPS flashes.
05 Warning signal The function is used to cyclically switch on/off a signal transmit-
ter while the door is opening or closing.
06 Electric strike For the connection of an additional electric strike
08 closed lock The function is used to signal the door mode, e.g. to a building
control centre.
09 Closed
10
Not closed
11 Open
12 Off
13 Night
14
Exit only
15 Automatic
16
Hold open
17 Light control The function is used to activate a light controlling device which,
for example, switches on the entry illumination as soon as a con-
tact sensor (KI, KA, KB, SIS+KI, SIS+KA) is activated or the door is
opened manually.
18 Day/Night changeover The function is used to signal the day mode of operation to a
customer building control centre. The output switches to GND if
the mode of operation LS, AU 1-leaf, DO, or AU 2-leaf is set.
19 Not used
20 Maintenance due The function is used to signal the door mode, e.g. to a building
control centre.
21 holding magnet GF To set the active leaf holding magnet.
22 holding magnet SF To set the passive leaf holding magnet.
24 WC timeout To connect a lamp or a signal to signal when the 30-minute
timer has expired for the WC function.
f0
Opening force 01 … 15 … 25 ×10 N;
Open static force at the main closing edge.