Gewa Control Omni, Setting Manual

Page: 24 / 52

24
To be able to add GR unit you must understand the vocabulary below:
Include GR unit (Include)
Include GR unit on Control Omni which shall be able to control.
Exclude GR unit (Exclude)
Exclude GR unit from Control Omni (is recommended if GR unit is available).
Remove GR unit from list
Exclude GR unit from the list in Control Omni. Is to be used if GR unit is not available.
Switch Multi level
A dimmer function with different buttons for different dimmer levels.
Switch Multi level Toggle
Off/on-function where
“On” is the last selected dimmer level.
Switch Binary
On/off-function. Two buttons are taken, one for
“Off” and one for “On”.
Switch Toggle
Off/on-function. A button for both
“Off” and “On”.
Configuration
Functions which are to be set for each unit that are to be programmed. You find these
functions in the manual for each product.
Press function
The function is activated when the transmitter button is pressed.
Release function
The function is activated when the transmitter button is released.
Association
Include other GR transmitters which are to work in parallel with Control Omni. Note! Control
Omni must always act as Primary transmitter which means starting to program Control Omni
and then add other GR transmitters. To include other GR transmitter we recommend you to
read the GR manual.
Confirmation Off/On
Your Control Omni gives confirmation as to whether a GR function is performed or not. If the
function is not performed, a “Not performed” alert sounds. It takes a few seconds before
confirmation is given. For example it can be useful when you want to switch on a lamp in
another room. If the desired function has been performed, no alert is given, ie. the lamp has
been switched on so the transmitter is silent.