Gestetner A265, Service Manual

Page: 841 / 855

Netw
ork
In
terf
ace
Board B3
07
INSTALLATION
SM 2-3 A265/A267
2.3.2 TCP/IP NETWORKS
The following parameters are available for TCP/IP network printing.
Parameter Description
Protocol
(Default = Enabled) Disable this if TCP/IP is not used.
IP Address
(Default = 11.22.33.44) IP address of the NIB (required)
Subnet Mask
(Default = 0.0.0.0) Subnet mask for the subnet (required)
Default Gateway
(Default = 0.0.0.0) Default gateway of the subnet. This is required when the
NIB is accessed from a host in a different subnet.
Access Control Address
Access Control Mask These two parameters are used to allow access to the NIB
only to the hosts in the specified subnet.
For example, if the Access Control Address is set to
“128.1.2.3”, access to the NIB is restricted as follows:
•
When Access Control Mask is “255.0.0.0”, hosts in the
128.0.0.0 subnet can access the NIB.
•
When Access Control Mask is “255.255.0.0”, hosts in
the 128.1.0.0 subnet can access the NIB.
•
When Access Control Mask is “255.255.255.0”, hosts in
the 128.1.2.0 subnet can access the NIB.
•
When Access Control Mask is “255.255.255.255”, only
the host that has the IP address 128.1.2.3 can access
the NIB.
Network Boot Use “NONE” when an IP address is specified manually
(default), or use “DHCP” if the NIB receives an IP address
from a DHCP server.
All the other settings may not be used, unless the NIB is
installed in, for example, a UNIX network.
•
RARP + TFTP
•
BOOTP
•
RARP + BOOTP
•
ARP + PING
•
ARP & RARP
•
ARP & BOOTP
•
ARP & RARP & BOOTP
Frame Type Ethernet II is always used.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA