Gestetner A265, Service Manual

Page: 272 / 855

FIRMWARE MODIFICATION HISTORY
A265/A267 4-84 SM
4.6 FIRMWARE MODIFICATION HISTORY
4.6.1 BICU Firmware Modification History
A265/A267 Firmware Modification History (BICU)
Description of Modification
Firmware
Level
Serial
Number
Firmware
Version
Initial Production
A2675532 B
From initial
production. 1.57
Corrects the following:
•
The machine goes into Energy Saver Mode
when the operator presses the Energy Saver
Mode key while a print job is in progress.
However, when the operator brings the machine
out of the mode and returns to System Settings
or Copy Features (both inside user tools), a
message is displayed asking the operator to
wait and the machine returns to the main copy
screen. At this time, the LED for the user tools
key is lit, and all indicators except the LCD
report that the machine is still in User Tools.
•
If the operator enters System Settings or Copy
Features (both inside user tools) from Fax,
Printer or Scanner mode while a duplex or
staple copy job is in progress, the “Copy in
progress” screen is displayed.
The message is still displayed even if the
operator presses the User Tools Key to return to
the main copy screen after the copy job finishes.
•
If a jam occurs while printing out a counter
report, the jam indication is displayed but soon
disappears. The machine then returns to the
counter display screen. In addition, if the paper
end condition occurs while the paper is being
fed, the machine returns to the counter display
screen without properly displaying “Set A4 (81/2
X 11) paper in tray”.
•
On machines with an optional LCT installed,
SC507 can occur when the main power SW is
turned on under the following conditions: 1. The
LCT end fence is not in the HP
and 2. The
bottom plate for the right tray is not detected by
the lower HP sensor.
However, these occurrence conditions are very
rare.
•
“1/2” appears in the Key Operator Tools display
(inside user tools – system settings).
•
After the operator exits either of the following
screens with the User Tools key and starts a
copy job, the first sheet is printed out as the
counter list.
!
System Settings – Key Operator
Tools – Counter List Printing
!
Copy Features– Key Operator
Tools – Counter List Printing
A2675532 C October
1999
Production.
1.64
⇒
Rev. 02/2001
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA