Gestetner A265, Service Manual

Page: 728 / 855

ERROR CODES
A265/A267 7-6 SM
Code Meaning Suggested Cause/Action
0-87 The control channel started
after an unsuccessful
primary channel.
•
The receiving terminal restarted the control
channel because data reception in the primary
channel was not successful.
•
This does not result in an error communication.
0-88
The line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
•
Try using a lower data rate at the start.
•
Try adjusting the cable equalizer setting.
2-10 The modem cannot enter
tx mode
•
Replace the FCU.
2-11 Only one V.21 connection
flag was received
•
Replace the FCU.
2-12 Modem clock irregularity
•
Replace the FCU.
2-13 Modem initialization error
•
Turn off the machine, then turn it back on.
•
Update the modem ROM.
•
Replace the FCU.
2-20 Abnormal coding/decoding
(cpu not ready)
•
Replace the FCU.
2-23 JBIG compression or
reconstruction error
•
Turn off the machine, then turn it back on.
•
Replace the EXFUNC board if the error is
frequent.
2-24 JBIG ASIC error
•
Turn off the machine, then turn it back on.
•
Replace the EXFUNC board if the error is
frequent.
2-25 JBIG data reconstruction
error (BIH error)
2-26 JBIG data reconstruction
error (Float marker error)
2-27 JBIG data reconstruction
error (End marker error)
2-28
JBIG data reconstruction
error (Timeout)
•
JBIG data error
•
Check the sender’s JBIG function.
•
Update the FCU ROM.
2-50 The machine resets itself
for a fatal FCU system
error
•
If this is frequent, update the ROM, or replace
the FCU.
2-51 The machine resets itself
because of a fatal
communication error
•
If this is frequent, update the ROM, or replace
the FCU.
3-00 G4 interface board reset
•
Replace the G4 interface board or FCU.
3-10 Disconnection during ISDN
G3 communication
•
Check the other terminal and the ISDN line.
•
The other terminal may have dialed a wrong
number.
3-11 Disconnection during ISDN
G4 communication
•
Check the other terminal and the ISDN line.
3-20 A CSA signal was received
during ISDN G4
communication
•
The operator at the other terminal may have
interrupted the communication.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA