Gestetner A265, Service Manual

Page: 645 / 855

BIT SWITCHES
SM 4-41 A265/A267
Serv
ic
e
Ta
b
le
s
A8
9
5
Printer Switch 0F
No FUNCTION COMMENTS
6
to
7
Wait timer for duplex printing
If the duplex unit is already being used for a copy or print job when the fax unit is
going to print a fax message in duplex mode, the fax unit waits until the duplex unit
becomes available. The time that the fax unit will wait can be specified, as shown
above. It the timer expires, the message is printed on single sides.
4.2.4 COMMUNICATION SWITCHES
Communication Switch 00
No FUNCTION COMMENTS
0
to
1
Compression modes available
in receive mode
Bit 1 0 Modes
0 0 MH only
0 1 MH/MR
1 0 MH/MR/MMR
1 1 MH/MR/MMR/
JBIG
These bits determine the compression capabilities
to be declared in phase B (handshaking) of the
T.30 protocol.
2
to
3
Compression modes available
in transmit mode
Bit 3 2 Modes
0 0 MH only
0 1 MH/MR
1 0 MH/MR/MMR
1 1 MH/MR/MMR/
JBIG
These bits determine the compression capabilities
to be used in the transmission and to be declared
in phase B (handshaking) of the T.30 protocol.
4 Not used Do not change the settings.
5 JBIG compression method:
Reception
0 : Only basic supported
1 : Basic and optional both
supported
Change the setting when communication
problems occur using JBIG compression.
6 JBIG compression method:
Transmission
0 : Basic mode priority
1 : Optional mode priority
Change the setting when communication
problems occur using JBIG compression.
7 Closed network (reception)
0: Disabled
1: Enabled
1: Reception will not go ahead if the ID code of
the other terminal does not match the ID code of
this terminal. This function is only available in
NSF/NSS mode.
=No Limit, =1 m in., =3 m in., =10 min.
1
0
0
0
0
1
1
1
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA