Gestetner A265, Service Manual

Page: 730 / 855

ERROR CODES
A265/A267 7-8 SM
Code Meaning Suggested Cause/Action
6-04 G3 ECM - RTC not
detected
•
Check the line connection.
•
Check connections from the NCU to the FCU.
•
Check for a bad line or defective remote
terminal.
•
Replace the FCU or NCU.
6-05 G3 ECM - facsimile data
frame not received within
18 s of CFR, but there was
no line fail
•
Check the line connection.
•
Check connections from the NCU to the FCU.
•
Check for a bad line or defective remote
terminal.
•
Replace the FCU or NCU.
•
Try adjusting the rx cable equalizer
Cross reference
•
Rx cable equalizer - G3 Switch 07 (PSTN)
6-06 G3 ECM - coding/decoding
error
•
Defective FCU.
•
The other terminal may be defective.
6-08 G3 ECM - PIP/PIN
received in reply to
PPS.NULL
•
The other end pressed Stop during
communication.
•
The other terminal may be defective.
6-09 G3 ECM - ERR received
•
Check for a noisy line.
•
Adjust the tx levels of the communicating
machines.
•
See code 6-05.
6-10 G3 ECM - error frames still
received at the other end
after all communication
attempts at 2400 bps
•
Check for line noise.
•
Adjust the tx level (use NCU parameter 01 or
the dedicated tx parameter for that address).
•
Check the line connection.
•
Defective remote terminal.
6-21 V.21 flag detected during
high speed modem
communication
•
The other terminal may be defective or
incompatible.
6-22 The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel
•
Check for line noise.
•
If the same error occurs frequently, replace the
FCU.
•
Defective remote terminal.
6-99 V.21 signal not stopped
within 6 s
•
Replace the FCU.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA