Gestetner A265, Service Manual

Page: 723 / 855

ERROR CODES
SM 7-1 A265/A267
T
rouble
-
s
hooting
A8
9
5
7. TROUBLESHOOTING
7.1 ERROR CODES
If an error code occurs, retry the communication. If the same problem occurs, try to
fix the problem as suggested below. Note that some error codes appear only in the
error code display and on the service report.
Code Meaning Suggested Cause/Action
0-00 DIS/NSF not detected
within 40 s of Start being
pressed
•
Check the line connection.
•
Check the NCU - FCU connectors.
•
The machine at the other end may be
incompatible.
•
Replace the NCU or FCU.
•
Check for DIS/NSF with an oscilloscope.
•
If the rx signal is weak, there may be a bad
line.
0-01 DCN received
unexpectedly
•
The other party is out of paper or has a
jammed printer.
•
The other party pressed Stop during
communication.
0-03 Incompatible modem at the
other end
•
The other terminal is incompatible.
0-04
CFR or FTT not received
after modem training
•
Check the line connection.
•
Check the NCU - FCU connectors.
•
Try changing the tx level and/or cable
equalizer settings.
•
Replace the FCU or NCU.
•
The other terminal may be faulty; try sending to
another machine.
•
If the rx signal is weak or defective, there may
be a bad line.
Cross reference
•
Tx level - NCU Parameter 01 (PSTN)
•
Cable equalizer - G3 Switch 07 (PSTN)
•
Dedicated Tx parameters - Section 4
0-05 Unsuccessful after modem
training at 2400 bps
•
Check the line connection.
•
Check the NCU - FCU connectors.
•
Try adjusting the tx level and/or cable
equalizer.
•
Replace the FCU or NCU.
•
Check for line problems.
Cross reference
•
See error code 0-04.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA