Gestetner A265, Service Manual

Page: 828 / 855

FIRMWARE HISTORY
A265/A267 6-8 SM
B306 PRINTER OPTION FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION FIRMWARE
LEVEL
SERIAL
NUMBER
FIRMWARE
VERSION
•
When using the Dazel system, the job
cannot be reset after the paper feed tray
reaches paper end
•
When printing out with a certain macro,
the frame and lower area of the image
are missing
•
When using a certain DOS (CAD)
application, the paper size and/or paper
feed direction are not sent to the
controller, and the machine uses the
defaults.
•
When printing out from a certain DOS
application, the right part of the internal
print pattern is missing.
B3065280 G Dec.2000
Production
1.4.8
• The “Paper Type” information does not
listed in the configuration sheet when the
by-pass feed unit is installed
•
The controller stalls when the test
document (A4 LEF) for Corel Draw 9 is
printed.
• . Using the PCL 6 driver when printing an
MS Word 97 or Word Pad document. If
the following functions are enabled, the
front side only is printed out in Top
Binding. The rear side only is printed out
in Side Binding:
Duplex-SIDE BINDING and in Paper
mode Different Paper for First Page
(First Page from 1 or 2 Tray and Other
Pages from Tray 3 or 4; Destination –
Printer Default).
This problem doesn’t occur with PCL5e
driver.
• After an A4 LEF print job is completed
and the ON Line key is pressed, it takes
a relatively long time to enter OFF Line
mode.
• Add Toner condition occurs during
printing with staple mode. The machine
does not print out the remaining page
even if the toner bottle is replaced
B3065280 H Jan.2001
Production
1.4.9
⇒
Rev. 05/2002
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA