7
ENGLISH
G-BAT ENV AUTOMATED SYSTEM
The
G-BAT ENV
automated system for gates with swing leaves is
an operator which transmits movement to the leaf via a worm
screw system.
A handy release system makes it possible to move the gate ma-
nually in the event of a power cut or operator faults.
L’ operator
G-BAT ENV
is planned for control of accesses of the
vehicle to residential use.
Before you start installing the operator, read this manual to the
letter.
Store the manual for any future references.
Correct operation and the declared technical characteristics
can be obtained only by respecting the indications in this
manual and using GENIUS accessories and safety devi-
ces.
To ensure an adequate degree of safety for the automated
system, the absence of a mechanical clutch device, calls
for the use of a control unit with an adjustable electronic
clutch device.
The G-BAT ENV operator was designed and built to control
vehicle access – AVOID ANY OTHER USES.
Anything not expressly specified in this manual is not permit-
ted.
. DESCRIPTION
Fig. 1
a
Operator
b
Transmission pipe
c
Release key
d
Rear fastening bracket
e
Front fastening bracket
f
Fastening pins
g
Elastic rings
.. TECHNICAL SPECIFICATIONS
Model
G-BAT ENV
Power suply voltage and frequency
24 Vdc
Absorbed power
35 W
Absorbed current
1.5 A
Max.thrust force
150 daN
Rated thrust force
100 daN
Rod stroke
300 mm/400 mm
Rod linear speed
2.1 cm/sec
Operating ambient temperature
-20 °C — +55°C
Type and use frequency
Residential
Recommended daily cycles
≤80
Maximum consecutive cycles at 20°C
≤30
Noise
<70 dB (A)
Operator weight
6.5 Kg/7Kg
Protection class
IP 54
Maximum leaf length
a
3 m /4 m
a
For leaves of over 2.5 m, an electrical lock is necessary
to guarantee leaf blocking
.2. DIMENSIONS
Fig. 2
2. INSTALLATION
2.. ELECTRIC PREPARATIONS (STANDARD SYSTEM )
To lay cables, use adequate rigid and/or flexible tubes.
To avoid any type of interference, we advise you to always
separate the 230/115Vac power cables from the low vol-
tage command cables, using separate sheaths.
If it is necessary to extend the motor power cable, use a cable
suitable for outdoor mobile laying.
Fig. 3
a
Operator
b
Control unit
c
Closing safety devices
d
Opening and closing safety devices
e
Opening mechanical stops
f
Key-operated selector switch
g
Flashing lamp