Moxi GO II
™
User Guide
Page 65
Put the Moxi GO II
TM
in USB Connect mode
i.
Touch the “USB Disk” icon (image above/left)
ii.
Touch the “Connect Disk” icon (image above/middle)
iii.
Wait for the “Connected” icon to light up (image above/right).
Notes:
•
It may take a couple of minutes to light up.
•
Once that disk is connected, the Moxi GO II disk will appear as an external drive
on your computer. On Mac’s, the drive will appear in the Mac Finder under
“Devices” as “Moxi Go2 SD”. On Windows computers, it will appear in the File
Explorer as a flash drive (e.g. “E:”)
•
If the Moxi GO II is not physically connected to the computer, you will receive a
message “USB Connection: Please connect a USB cable to a PC host first”
i. Once connected, the computer will have full control over the Moxi GO II files. This
allows for:
•
Copying or cut-and-paste of files from the Moxi GO II to a computer
•
Deleting files from the Moxi GO II system
•
Adding older FCS data to the Moxi GO II system by copying them to the “Test-
Files” directory
•
Renaming of test file names
Note: The data and image files are located in the “Test-Files” sub-directory. There is
one FCS file per test. The Cell QC batch runs are saved in sub-folders (named with the
batch name) under the Test-Files directory.
