913225/CP0807
60
PRINTED IN U.S.A.
B5 - HYDRAULIC OIL LEVEL
CHECK
Park the telescopic handler on level ground with the
engine stopped, and the boom retracted and lowered as
far as possible.
- Refer to sight gauge (1) (fig. B5/1).
- The oil level is correct when it is at the level of the
red point.
- If necessary, add oil (see chapter: 6 - MAINTE-
NANCE: LUBRICANTS AND FUEL).
- Open the right side cover.
- Remove filler cap (2) (fig. B5/2).
- Add oil at filler neck (3) (fig. B5/2).
- Replace the cap.
- Visually check that there is no leakage from the
reservoir and pipes.
Always maintain the oil level at the maximum, because
cooling depends on oil flowing through the reservoir.
B6 - BRAKE OIL LEVEL
CHECK
Park the telescopic handler on level ground.
- Loosen screw (1) (fig. B6/1) and remove the access
panel for the brake fluid reservoir and windshield
washer tank (2) (fig. B6/1).
- The level is correct when it is at the MAX level on
the reservoir.
- If necessary, add oil (see chapter: 6 - MAINTE-
NANCE: LUBRICANTS AND FUEL) at the filler
neck (3) (fig. B6/2).
- Visually check that there is no leakage at the reser-
voir and connections.
B7 - WINDSHIELD WASHER FLUID
LEVEL
CHECK
- Loosen screw (1) (fig. B7/1) and remove the access
panel for brake fluid reservoir and windshield wash-
er tank (2) (fig. B7/1).
- Visually check the level.
- If necessary, add windshield washer fluid (see chap-
ter: 6 - MAINTENANCE: LUBRICANTS AND
FUEL) at filler neck (3) (fig. B7/2).
B8 - CAB DOOR - CT5-16 Turbo
GREASE
Clean and lubricate the points (1) (four fittings) (fig.
B8) with grease (see chapter: 6 - MAINTENANCE:
LUBRICANTS AND FUEL). Remove any excess
grease.
B5/1
B5/2
1
3
2
B6/1
B6/2
2
1
3
B4/7
B4/8
7
9
