![background image](http://html1.mh-extra.com/html/gehl/ct5-16/ct5-16_operators-manual_2205873066.webp)
913225/CP0807
64
PRINTED IN U.S.A.
D1 - ENGINE OIL
DRAIN
D2 - ENGINE OIL FILTER
CHANGE
Park the telescopic handler on level ground, let the
engine run at idle for a few minutes, and then stop the
engine.
DRAINING THE OIL
- Open the engine cover.
- Remove access panel (1) (fig. D1/1).
- Place a container under drain plug (2) (fig. D1/2)
and unscrew the plug.
D1/1
D1/2
2
6
8
1
ADJUSTMENT OF THE PARKING BRAKE
- Leave the parking brake in position B (fig. C4/1).
- Progressively tighten the end piece of the lever 5
(fig. C4/1) and recheck braking.
- Repeat the operation until the correct braking adjust-
ment is obtained.
C5 - CAB VENTILATION FILTER
CHANGE
- Remove access cover (1) (fig. C5).
- Slide out cab ventilation
filter (2) (fig. C5) and
replace with new filter
(see chapter: 6 - MAIN-
TENANCE: FILTER
CARTRIDGES AND
BELTS).
- Re-install the filter and
access cover.
C6 - FRONT AND REAR AXLE DIFFER-
ENTIAL OIL LEVEL
CHECK
Park the telescopic handler on level ground with the
engine stopped.
- Remove level plug (1) (fig. C6). The oil should be
flush with the edge of the hole.
- If necessary, add oil (see chapter: 6 - MAINTE-
NANCE: LUBRICANTS AND FUEL) by the same
filler port.
- Replace and tighten the level plug (1) (fig. C6)
[tightening torque: 25 to 36 lbs.-ft. (34 to 49 Nm)].
- Repeat this operation for the rear axle differential.
C7 - FRONT AND REAR AXLE
PLANETARIES OIL LEVEL
CHECK
Park the telescopic handler on level ground with the
engine stopped.
C6
1
D - EVERY 500 HOURS
SERVICE
Perform the operations described previously as
well as the following operations:
C5
1
2
- Check the level on both front axle planetaries.
- Place level plug (1) (fig. C7) in the horizontal posi-
tion.
- Remove the level plug; the oil should be flush with
the edge of the hole.
- If necessary, add oil (see chapter: 6 - MAINTE-
NANCE: LUBRICANTS AND FUEL) through the
same hole.
- Replace and tighten the level plug (1) (fig. C7)
[tightening torque: 25 to 36 lbs.-ft. (34 to 49 Nm)].
- Repeat the operation on both rear axle planetaries.
C7
1