![background image](http://html1.mh-extra.com/html/gehl/ct5-16/ct5-16_operators-manual_2205873070.webp)
913225/CP0807
68
PRINTED IN U.S.A.
E1 - FUEL TANK
CLEAN
Park the telescopic handler on level ground with the
engine stopped.
- Inspect the fuel system and tank for leaks.
- In the event of a leak, contact your dealer.
- Place a container under drain plug (1) (fig. E1/1) and
unscrew the plug.
- Open the engine cover.
-Remove cap (2) (fig. E1/2).
- When fuel tank is drained, rinse with 2-1/2 gallons
(10 litres) of clean fuel at filler port (3) (fig. E1/2).
WARNING
While carrying out these operations, do not
smoke or work near an open flame.
- Do not perform this check immediately after topping
up with distilled water. Recharge the battery for at
least an hour before checking the battery electrolyte
density.
D9 - TRANSFER BOX OIL
DRAIN
Park the telescopic handler on level ground with the
engine stopped and the transfer box oil still warm.
IMPORTANT:
Dispose of the drain oil in an eco-
logical manner.
- Remove access panel (1) (fig. D9/1).
- Place a container under drain plug (2) (fig. D9/2)
and remove the plug.
- Remove level and filler plug (3) (fig. D9/2) in order
to ensure the oil is drained properly.
- Replace and tighten the drain plug (2) (fig. D9/2)
[tightening torque: 25 to 36 ft.-lbs. (34 to 49 Nm)].
- Fill with oil (see chapter: 6 - MAINTENANCE:
LUBRICANTS AND FUEL) by filler port 3 (fig.
D9/2).
- The level is correct when the oil is flush with the
edge of the level hole (3) (fig. D9/2).
- Check for any possible leaks at the drain plug.
- Replace and tighten the filler plug (2) (fig. D9/2)
[tightening torque: 25 to 36 ft.-lbs. (34 to 49 Nm)].
- Replace the access panel (1) (fig. D9/1).
D10- FRONT AND REAR AXLE
DIFFERENTIAL OIL
DRAIN
Place the telescopic handler on level ground with the
engine stopped and the differential oil still warm.
- Place a container under drain plug 1 (fig. D10) and
unscrew the plug.
- Remove level and filler plug (2) (fig. D10) to ensure
that the oil drains properly.
- Replace and tighten drain plug (1) (fig. D10) [tight-
ening torque: 25 to 36 ft.-lbs. (34 to 49 Nm)].
D9/2
3
2
D9/1
1
E - EVERY 1000 HOURS OF
SERVICE
Perform the operations described previously as well
as the following operations:
WARNING
Never weld while alone, because welding can
cause an explosion or a fire.
- Fill with oil (see chapter: 6 - MAINTENANCE:
LUBRICANTS AND FUEL) at filler port (2) (fig.
D10).
- The level is correct when the oil level is flush with
the edge of port (2) (fig. D10).
- Check for any leaks at the drain plug.
- Replace and tighten level and filler plug (2) (fig.
D10) [tightening torque: 25 to 36 ft.-lbs. (34 to 49
Nm)].
- Repeat this operation for the rear axle differential.
D10
1
2