Geely FC, Workshop Manual

Page: 276 / 419

2. Only scrap airbag module
1. Explosion of safety airbag assembly at the side of driver.
(1) Prepare a battery as detonating power (12±1)V.
(2) Disassemble safety airbag assembly at the side of driver, and connect the airbag short wiring harness
on gas generator.
Warning: when storing safety airbag module at the side of driver, it is necessary to keep upper
surface face upwards.
Supplemental restraint system--Scrap treatment for safety airbag
(7) Safety airbag assembly at the side of driver after explosion should be scraped by the scrap main points.
Note: Firstly, confirm whether there are people on automobile and near the automobile, do
not operate until confirming none there.
After the safety airbag at the side of driver is unfolded, its gas generator temperature is
high, do not make any treatment until putting it for over 30 minutes to wait for it be-
comes cool.
If safety airbag assembly at the side of driver could not be unfolded, it is necessary to
contact with local appointed repairing station.
3. Safety airbag assembly at the side of passenger.
(1) Disassemble the glove box.
(2) Disassemble the connector between airbag short wiring harness and airbag wiring harness.
(3) Connect the conversion wiring harness of safety airbag with one wiring harness with over 10 m used
for unfolding, and the connecting part should be twisted with insulation adhesive tape to insulate and
prevent from wrong unfolding for static.
(4) Connect conversion wiring harness of safety airbag on yellow joint of helix cable, then lead it out of
automobile with unfolding wiring harness (see following figure).
265
(5) Close all windows and doors, and assemble automobile
cover.
(6) Cut off the joint of wiring harness used for unfolding of safety
airbag assembly at the side of driver at the place apart from
the automobile, then connect it with two ends of battery
taken from automobile to make it unfold (see following figure).
(7) Safety airbag assembly at the side of driver after explosion
should be scraped by the scrap main points.
Note: Firstly, confirm whether there are people on automobile and near the automobile, do not
operate until confirming none there.
After the safety airbag at the side of driver is unfolded, its gas generator temperature is
high, do not make any treatment until putting it for over 30 minutes to wait for it be-
comes cool.
If safety airbag assembly at the side of driver could not be unfolded, it is necessary to
contact with local appointed repairing station.
Cover of automobile body
Wiring harness for explosion