Geely FC, Workshop Manual, Page: 137 / 419

18. Assemble left front lower control arm ball head as-
sembly [64000093]
(a) Assemble lower ball head and locking nut.
Torque: 103
±±±±±
10 N
⋅⋅⋅⋅⋅
m
(b) Assemble new cotter pin.
If hole position of cotter pin could not make a line, lock the
screw cap for 60 again.
19. Assemble left front shaft hub assembly
(a) Assemble two bolts and nuts, and assemble shaft hub as-
sembly on absorber.
Torque: 153
±±±±±
10 N
⋅⋅⋅⋅⋅
m
Note: when the bolts and nuts should be used again,
spread engine oil on the thread of nuts.
(b) Push the front shaft hub assembly to the outside of
automobile, then assemble transmission shaft assembly
in the gear slot of front shaft hub assembly.
Note:
Front shaft assembly could not be pushed to outside
too much.
z
Do not damage the exterior joint dustproof cover of
drive shaft.
z
Do not damage the stator of speed sensor.
20. Assemble left lower control arm assembly
[64000091]
Assemble lower control arm and ball head with two nuts and
bolts.
Torque: 142
±±±±±
10 N
⋅⋅⋅⋅⋅
m
21. Assemble left transversal lever assembly
(a) Connect transversal lever to steering knuckle.
(b) Assemble screw cap and new cotter pin.
Torque: 49
±±±±±
5 N
⋅⋅⋅⋅⋅
m
22. Assemble left front brake assembly [64000134]
23. Assemble front brake caliper assembly
(a) Assemble brake caliper assemble on steering knuckle with
two bolts.
Torque: 106
±±±±±
10 N
⋅⋅⋅⋅⋅
m
24. Assemble fixing nuts of left front drive shaft
[64000083]
Use torque wrench (30mm) to assemble new fixing nuts.
25. Disassemble left front brake branch pump assembly
26. Disassemble left front brake assembly [64000134]
27. Check the axial clearance of bearing
Drive shaft--Left front shaft hub assembly
126