29
in.xe
™
In.xe™ programming field options
In the event where none of the pre-determined low level program
configurations built in the in.xe™ system suit your spa equipment
assembly, it's possible to custom configure the in.xe™ system by
manually entering key parameter settings.
Parameter
Display
Options
Description
Pump 1 Config
Single-speed = 1
Dual-speed = 2
*Pump #1 and Pump #3 = 3
Pump #1 configuration
*Available only on certain models.
Pump 2 Config
Not installed = 0
Single-speed = 1
Dual-speed = 2
Pump #2 configuration
Blower Config
Not installed = 0
Installed = 1
Blower configuration
Circ. Pump Config
Not installed = 0
Installed = 1
Always on = 2
Circulation Pump configuration
Ozone Config
Not installed = 0
During filter cycle = 1
Always on = 2
Ozone generator configuration
Ozone Pump
Circulation pump = 0
Pump #1 = 1
Pump associated to Ozone generator
Ozone Type
Standard = 0
Timed = 1
Type of Ozone generator
Heater Pump
Circulation pump = 0
Pump #1 = 1
Pump associated to Heater
programming the in.xe™
To access this menu, press and hold
Prog
. (or
Light
key) for
30 seconds. Use
Up
or
Down
key to choose setting.
Press
Prog
. key (or
Light
key) to go to the next parameter.
Please note that there are three
versions available of field options
depending on your software
revision. The table 1 & 2
were use with previous versions.
The table 3 is the latest version.
The first parameter will help to
indicate you wich table it is.
( = table 1) and ( = table 2 or 3)
Table 1
--