10
in.xe
™
The following material is
recommended:
4- # 10 screws of appropriate
length with round, truss or
pan head.
4- washers 1/2” OD x 1/16”
thickness (12 mm OD x 1,5 mm)
Select the most appropriate
location on the floor for spa
pack and firmly attach guide
plate to wooden base with (2)
screws backed by (2) washers.
Slide back side of the unit's feet
into the guide plate. It should
easily slide into place.
Now firmly attach unit to
wooden base by using the
remaining (2) screws backed
by (2) washers to fix the front of
the foot.
Note:
The spa pack must be
installed at least 4 inches
(52 mm) above potential flood
level. If floor is on ground level,
pack should be raised at least
4 inches (52 mm).
Floor installation procedure
4"
Important!
Please note that
countersunk
screws should
not
be used as
they can damage the power
box support.
installation
Warning:
Beware the application of some products commonly used against
corrosion (such as WD-40 family products) could damage the
power box, due to a negative chemical reaction between some
industrial oils and its plastic enclosure. Any other materials
which may come in contact with the enclosure must be carefully
evaluated under end use conditions for compatibility.