11
in.xe
™
Firmly attach lower mounting
holes on each side of the pack
with the (2) remaining screws
and (2) washers.
The following material is
recommended:
4- # 10 screws of appropriate
length with round, truss or
pan head.
4- washers 1/2 OD x 1/16”
thickness (12 mm OD x 1,5 mm)
Use two (2) standard 2 x4
or 2x6 wall studs, spaced on
16-inch centers to affix the
spa pack.
Wall installation procedure
installation
In the case of a flat wooden
surface: select the most
appropriate location on wall
for the spa pack. A square
cut-out of about 4 inches (52
mm) per side will be needed
to allow the transformer to fit
through it.
Firmly attach, one at the time,
upper mounting holes on each
side of the spa pack with (2)
screws backed by (2) washers.
Note:
Make sure these (2)
screws and (2) washers are
installed. They will make
the pack stable when input,
outputs and accessory
connectors will be inserted in
their ports.