GE Vivid S5 N, Service Manual

Page: 542 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
8-16 Section 8-2 - Cover Replacement Procedures
P R E L I M I N A R Y
8-2-5-4 Left Rear Cover Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the
Left Rear Cover Removal Procedure .
1) Return the left rear cover to its original position at the rear of the main assembly frame, taking care
to tilt it sufficiently so that the lower portion overlaps the system chassis on the left side - refer to
Figure 8-17 on page 8-15 .
2) Carefully align the two securing hooks located on the inner right side of the cover (refer to
Figure 8-16 on page 8-14 ) with the holding screws on the main assembly frame, then push the
cover downwards to secure it in position.
3) Return the screw (previously removed) to the securing tab on the inner left side of the cover and
tighten securely - refer to Figure 8-15 on page 8-14 .
4) Return the Basket (as described in the “Basket Installation Procedure” on page 8-20 ) and/or the
Tray (as described in the “Tray Installation Procedure” on page 8-22 ), as applicable.
5) Install the left side cover, as described in “Left Side Cover Installation Procedure” on page 8-7 .
6.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24