GE Vivid S5 N, Service Manual

Page: 696 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
8-170 Section 8-6 - Lower Section Components Replacement Procedures
P R E L I M I N A R Y
10.)Disconnect the power cable from the default printer - Figure 8-213 .
11.)Remove the AC Outlet Peripheral Connectors Panel.
8-6-12-4 Peripherals AC Outlet Connectors Panel Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the appropriate
movie clip previously referenced in the
Peripherals AC Outlet Connectors Panel Removal Procedure .
1.) Place the AC Cable Bracket sub-assembly ( Figure 8-214 ) into position on the system, carefully
aligning the bracket on top of the AC Distribution box - refer to Figure 8-208 on page 8-167 .
2) Return and fasten the two screws (previously removed) to secure the Peripherals AC Outlet
Connectors Panel onto the top of the AC Distribution box - refer to Figure 8-208 on page 8-167 .
3.) Reconnect the default printer cable.
NOTE: When positioning the AC to DIB cable, ensure that the plastic insulation spiral is properly positioned to
protect the cable from pressing against the DIB (see
step 4 ).
4.) Reposition the AC to DIB cable on the side of the DIB and align the plastic insulation spiral on the
AC to DIB cable so that the spiral is adjacent the DIB as shown in Figure 8-212 on page 8-169 .
5.) Reconnect the AC cable to the AC box.
Figure 8-213 Disconnecting the Printer Power Cable
Figure 8-214 AC Cable Bracket Sub-assembly
Printer Power Cable