GE Transport PT878, Abridged Manual

Page: 24 / 97

Initial Setup 2-1
August 2008
Introduction
The PT878 Program Menu enables you to program the parameters
that define an installation site. As a minimum, the transducer, pipe
and fluid data must be entered into the meter before measurements
can be taken. The programmed data can then be saved as a
site file ,
and the PT878 can store up to 1 MB (or 32 site files) of data.
IMPORTANT:
For menu options not discussed in this abridged
manual or if you see an error or warning screen while
programming your meter, refer to your full
User’s
Manual (910-219) for further instructions.
Entering the Program
Menu
To enter the Program Menu , press the
[MENU]
key at the lower right of
the PT878 keypad. The Menu Bar replaces the Status Bar at the top of
the screen. Press the [
X
] arrow key once to scroll to the Program
Menu and press [ENTER] (see Figure 2-1 below).
Note: As an aid in following the programming instructions in this
manual, refer to Appendix A,
Menu Maps .
Figure 2-1: The Program Menu
Use the [
T
]and [
S
] arrow keys to scroll through the menu options.
Then press
[ENTER]
to select that option.
Vel ocity, ft/s Signal, dB
0.00
32
Delta -T, ns
0.10
0.0
Volume, l/s
E0: No Errors
Pipe
Lining
Path
Fluid
Energy
Analog Input
Analog Output
Digital Output
User Functions
Site Program Meter Logging Service
Transducer
Co
Correction Factors