GE TMO2D, User Manual

Page: 17 / 102

TMO2D Digital Display User’s Manual 9
Chapter 2. Installation
2.3.2b CE Mark Compliance
IMPORTANT:
CE Mark compliance is required only for units used in EU countries.
For CE Mark compliance, you must use shielded cable and connect the shield to a cable gland (see Figure 3 on page 7).
After you make all the necessary electrical connections, seal the unused cable entry holes with standard conduit plugs
or their equivalent.
Note:
If you make the modifications as discussed here, your unit will comply with the EMC Directive 2004/108/EC.
Note:
For CE compliance, the I/O cables must be shielded. The shields are to be grounded within the TMO2D to the
closest location. Shielded cable is not required when installations include metal conduit.
Figure 5: XMO2 Wiring Connections
1
+24VDC Line (red) 1
2
3
4
2
3
–24VDC Return (black)
+4 to 20mA (white)
–4 to 20 mA (green)
RS232 TX (white)
RS232 GND (green)
2
3
4
1
3
External Ground Screw
Cover
Internal Ground Screw Set Screw
RS232 RX (red) 1
2