Masoneilan SVI II AP Digital Positioner Quick Start Guide
=
|
13
© 2015 General Electric Company. All rights reserved
.
Using the Quick Start Guide
The SVI II AP Quick Start Guide is intended to help an experienced field engineer install, setup, and
calibrate an SVI II AP in an efficient manner. This document provides basic installation and setup
instructions and is not intended to replace the in-depth information contained in the SVI II AP In-
struction Manual. If you experience problems that are not documented in this guide refer to the
SVI II AP Instruction Manual, call your local representative, or go to www.ge-energy.com/valves.
Sales offices are listed on the last page of this document
The steps necessary to complete the SVI II AP installation and software setup are outlined in
Table
1.
Table 1: SVI II AP Installation Steps
Step No.
Procedure
Reference
1
Attach mounting bracket to the actu-
ator.
See page
21 for rotary valve and
reciprocating valve instructions.
2
Install the SVI II AP magnetic assem-
bly (rotary valves only).
See page
21 for instructions.
3
Assemble the SVI II AP on the bracket
that is mounted to the valve actuator.
See page
21 for rotary valve and
reciprocating valve instructions.
4
Install the Remote Position Sensor, if
necessary.
See
Masoneilan Valve Solutions
Remote Position Sensor Quick
Start Guide
(GEA31195 or P/N
011525100-888-0000) for
instructions. Use GEA or P/N
when searching on the download
website).
5
Connect the pneumatic tubing to the
SVI II AP.
See page
33 for instructions.
6
Connect the air supply to the SVI II AP.
See page
34 for instructions.
7
Connect the positioner to the HART
®
Control Loop segment by installing
the SVI II AP wiring.
See page
35 for instructions.
8
Configure/calibrate using ValVue*.
See page
46 and page
49 for
instructions.
Configure/calibrate using a HART
®
Hand Held Communicator.
See page
53 for instructions.
