GE Security Legend IP, User Manual

Page: 111 / 140

Chapter 6
System operation
103
Keypad limitations for calling up presets
Most keypads have a limited number of preset numbers they can call up. (When you call up a preset, you are
using a preset command to move the dome’s camera to a preset position.) If you have a GE KTD-405 keypad
with firmware v1.2.09 or later, and it is operating with Impac RS-485 protocol, then you can call up all 127
preset numbers (1 through 127) directly from the keypad. If, however, you have a GE KTD-405 keypad with
an earlier version of firmware, or it is operating with Digiplex RS-422 protocol, then you can use the keypad to
call up only the first 63 preset numbers (1 through 63). If you are using presets 62 and 63 for your left and right
autopan limits, then you have a total of 125 or 61 preset numbers that you can call up from the keypad.
To verify your keypad’s version, press and hold the mon key on the keypad, until the keypad beeps, then press
the key.
To call up presets using a GE KTD-405 keypad:
1. Press the find key on the keypad.
2. Press the number keys for the desired preset number. You can either:
• Press the preceding zeros and the number. For instance, if you have more than a 100 domes in your
system, press
0 , 0 , and 7 for camera number 7.
• Press the number without the preceeding zeros and also press the set ( ) key. For instance, press
7 and set ( ).
To create presets, see Presets page on page 59.
To use the KTD-405 keypad, see KTD-405 Controller Keypad User Manual (1036547).