Falcon 60+ (-1)
Falcon 60+ (-1)
Operations Manual
© 2003 General Binding Corporation
Page 4
Service
Perform only the routine maintenance procedures
referred to in these instructions.
WARNING: Do not attempt to service or
repair the laminator.
Disconnect the plug from the receptacle and contact
GBC’s Technical Department or your
dealer/distributor when one or more of the following
has occurred.
- The power supply cord or attachment plug is
damaged.
- Liquid has been spilled into the laminator.
- The laminator is malfunctioning after being
mishandled.
- The laminator does not operate as described in
these instructions.
Important Safeguards
WARNING: TO GUARD AGAINST INJURY,
THE FOLLOWING SAFETY PRECAUTIONS
MUST BE OBSERVED IN THE
INSTALLATION AND USE OF THE LAMINATOR.
General
Keep hands, long hair, loose clothing, and articles
such as necklaces or ties away from the front of the
heat and pull rollers to avoid entanglement and
entrapment.
The heat rollers can reach temperatures over 300˚
F.
Avoid contact with the heat rollers during
operation or shortly after power has been removed
from the laminator.
Keep hands and fingers away from the path of the
sharp film cutter blade located at the film exit.
Do not use the laminator for other than its intended
purpose.
Avoid moving the laminator on uneven floor
surfaces. Never tilt the laminator.
Do not defeat or remove electrical and mechanical
safety equipment such as interlocks, shields and
guards.
Do not insert objects unsuitable for lamination or
expose the equipment to liquids.
Electrical
The laminator should be connected only to a source
of power as indicated in these instructions and on
the serial plate located on the rear of the laminator.
Contact an electrician should the attachment plug
provided with the laminator not match the
receptacles at your location.
CAUTION: The receptacle must be located
near the equipment and easily accessible.
Do not operate the laminator with a damaged power
supply cord or attachment plug, upon occurrence of
a malfunction, or after the laminator has been
damaged.
Contact GBC’s Technical Service
Department or your dealer/distributor for assistance.
Summary of Contents for Falcon 60+ (-1)
Page 1: ......