Falcon 60+ (-1)
Falcon 60+ (-1)
Operations Manual
© 2003 General Binding Corporation
Page 19
To Unwed the laminator
Unweb the laminator if you are changing film widths,
cleaning the rollers or have finished using the
machine for the day.
1. Using the rear slitter, cut (1) the output from the
web (Figure 32).
2. Cut (2) remaining top film web between the idler
bar and heat roller. PSA film, cut the release liner
too.
3. Cut (3) the film web between the lower film supply
and the idler bar (Figure 32).
CAUTION: Be careful not to cut any of the rollers!
4. Remove the safety shield and tilt the feed table.
5. Gap the main rollers and pull rollers.
6. Carefully grab hold of the web (top and bottom
film), from the front operating position and pull
towards you (Figure 33).
7. Do not allow the adhesive side of the film to
contact the heat or pull rollers.
Clearing a Film Jam (Wrap-up)
Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the
equipment is blocked. The film, when jammed,
wraps around the heat rollers during webbing if a
threading card is not used or pull rollers during
operation.
To clear a jam:
1. Immediately stop the laminator by pressing
STOP ( ).
2. Remove the safety shield and tilt the feed table.
3. Set motor direction to reverse.
4. Use the footswitch to reverse the web until the
wrap up is clear.
5. Raise the main roller and pull rollers.
6. Manually guide the web from the main rollers and
pull rollers.
7. Once the film jam has been cleared, lower the
main roller and pull rollers.
8. Refer to the section titled START LAMINATING.
Fig 32
Fig 33
Summary of Contents for Falcon 60+ (-1)
Page 1: ......
