Gastros InductWarm 20, Operating Manual

Page: 27 / 54

27
WARNING: When transporting, setting up, maintaining and repairing the InductWarm
®
200 device, the latest
version of the following regulations and guidelines that are applicable in your country must be observed (the list
is not exhaustive):


EC directives (in EU countries)

Accident prevention regulations

ons

Trade regulations
If the InductWarm
®
200 device is being installed in close proximity to a wall, partition walls, kitchen furniture,
decorative panelling etc., it is recommended that these objects consist of non-combustible material; otherwise
they must be covered with a suitable non-combustible, heat-insulating material and the fire safety regulations are
to be observed extremely carefully.
Intended use

WARNING: If the surface of coil carriers changes to darker colour or shows cracks, immediately
disconnect the appliance from the supply. Do not touch components on the inside of the device. Get in
contact with the Gastros servicepoint or an authorized service agent to initiate professional repair.

The surface of the InductWarm
®
200 device should not be used for storage.

Only use suitable pans with a minimum base diameter of 12 cm for induction warming. Theoretically, it
is possible to use smaller dishes, but this may result in the following:
o
Reduced efficiency
o
Pan recognition may not be possible
o
Radiation may be greater

Never heat a dish . This could cause the dish to overheat.

Once you have removed the pan after warming, remember to switch the InductWarm
®
200 device off,
unless you intend to use it again straight away. This will prevent the device from heating up accidentally
should you or someone else place a pan on the warming surface.

Do not heat up tins or other sealed containers, as these can explode! Items that are unsuitable for use
include any dishes that are not specifically intended for induction devices, as well as metal splash
guards, aluminum foil, cutlery, jewelry, watches, metallic objects etc.

The InductWarm
®
200 device is understood as switched on, when the specific LEDs at the operation
panel are blinking. When not using the warming device, please turn it off.