ANITA ©
13
4) CONTROL AND ADJUSTMENT OF THE MACHINE
Caution
Always turn off the power when mounting a needle. If the operator mistakenly steps on the pedal while
the power is on, the machine will start automatically and can result in physical injuries.
When using clutch motor, be aware that the motor will continue to rotate for a while even after the
power is switched off due to inertia. Start to work on the sewing machine only after the motor has
come to a complete stop.
4.1) Needle Insertion
With the needle groove (1) facing left, insert the needle tip into the upper end of the stopper hole (2)
and fasten the needle with the clamp screw (3). (See Fig.15)
(Fig. 15)
4.2) Needle Bar Adjustment
As is shown in Fig. 16, unscrew the rubber plugs (4) in the needle bar adjustment hole that is on the
face plate and turn the pulley so that the needle bar is in a down-stop position. Then turn loose the
clamp screws (5) on the needle bar handle, move the needle bar such that the lowest carved sign
on the needle bar (7) is in line with the bottom of the needle bar lower bushing (6), and tighten the
clamp screws of the needle bar handle. Lastly, plug in the rubber plugs (4).
!
Summary of Contents for GF-1116 Series
Page 30: ...ANITA 30...
